Gater WYZ34FS600V, Operator'S Manual

Page: 11 / 20

11
BELT ADJUSTMENT
Remove key from the ignition switch. The blade drive
belt may be accessed by removing belt shields. Spring
tension should be maintained by having
Approximately 1/8” stretch between coils. Turning the
nut on the eyebolt clockwise will decrease tension.
When installing a blade drive belt please refer to figure
3 for routing the blade drive belt. The pump belt
may be accessed from under the rear chassis. The
pump belt is removed by unhooking the tensioner
spring to provide slack in the belt for removal. When
installing a pump belt please refer to figure 4 for the
routing of the pump belt.
BYPASS VALVE
In some applications, it is desirable to move the machine
for short distances at low speeds without operating
engine. See fig. 6
DECK HEIGHT ADJUSTMENT
Height of cut positions are drilled at 1/2 inch
increments. To add 1/4 inch to the setting you must
first remove the #4 hairpin cotter, pull pin and rotate
the tab to the vertical position. The foot pedal must be
depressed slightly in order to replace the pin in tab. See
Fig. 5