01. Overview
NanoHARD
is a multifunctional programmable AEG Controller. It has 8 functions.
Thanks to its special coating, it is resistant to atmospheric conditions (Military
Specification MIL-V-173C). Battery protection supports: Li-Po 7.4V / 11.1V / 14.8V.
You can also disable the protection and use other batteries.
05
WWW.GATEE.EU
USER GUIDE
Key Functions
Do you want to achieve higher rate of fire and faster trigger response?
Are you planning power upgrade of your rifle? In that case, you need
a MOSFET.
It targets the energy from the battery directly to the motor, bypassing
the mechanical trigger contacts. As a result, you gain a higher rate
of fire of the rifle and faster trigger response, and the contacts
are protected against burn out.
MOSFET
Modern LiPoly batteries are very sensitive to over-discharge. If you do
not want to damage the battery and you care about its service life, this
protection is indispensable. The microprocessor constantly monitors
the battery voltage. When it drops down to a critical level, it will not
permit firing.
Protection against Over-Discharge of Battery (UVP Protection)
This provides full compatibility with the micro-switches. It is fully
resistant to contact bounce. You gain a bigger ROF, a faster trigger
response and your MOSFET is less prone to heating.
Debouncing (Digital Interface)
The usage of modern transistors and microcontroller has enabled us
to create the smallest and most reliable AEG Controller in the market.
3rd Generation MOSFET
14.8V LI-PO Ready
The system can be used with batteries up to 14.8V LI-PO. Minimum
operating voltage is 3V and maximum voltage is 17V.
