Food Slicer/Shredder Attachment
Operating
Before first use of the Food Slicer/Shredder Attachment
Remove all promotional materials and packing as well as any foreign objects, but do
not remove the model label. Before first use and after a long period of storage, clean
the processing tools in warm soapy water (see ´Care and Cleaning`).
Using the Food Slicer/Shredder Attachment
WARNING:
Always switch ´Off` the appliance, wait until the motor stops completely
and unplug the appliance before assembling/disassembling the attachment. To turn the
appliance ´Off` you have to turn the speed control anticlockwise into the ´Off`-position.
Assemble the Food Slicer/Shredder Attachment
1. Take the driveshaft into your right hand. The wider part
with the guiding pins has to face the front and the shaft
has to face backwards (picture A).
2. Take the application needed into your left hand.
WARNING:
The blades are very sharp. Pay attention
when handling the slice or shredder applications. Only
touch the applications on the margin when handling them.
Place the guiding pins of the driveshaft into the matching holes
in the bottom of the application (picture B).
3. Lock the driveshaft in position turning the driveshaft
clockwise (picture C).
4. Place the application together with the driveshaft into the
housing. The shaft has to face the housing when sliding the
application into the housing (picture D).
NOTE:
The application is correctly located when it is
pushed up all the way inside the housing and the end of
the shaft of the driveshaft pokes out of the back end of the
housing.
5. Take the ring nut and screw it onto the thread of the
housing turning it clockwise (picture D).
NOTE:
Do not tighten the ring nut too much to avoid
overwinding the thread.
14
A
B
C
D
98102_Gemueseschneider_DesKuechmaschAdv_manual.qxp 11.12.2007 15:04 Seite 14
