71
10.
To cancel the selected program, to interrupt the cooking process press and hold the ›Can-
cel / Keep Warm‹-button for a few seconds.
Please note that during the process the dough increases in volume or even doubles in volume.
To keep the dough from overflowing, the volume of the original ingredients should be located
under the ½ mark (2 l) on the inner surface of the inner pot.
During the proofing process of the dough it is nessesary to maintain a constant temperature
and humidity. For best results, do not open the appliance before the end of the program.
preparing fondue
With your Design Multicook Plus and the ›Mulicook‹-program you can easily prepare fondue
at home.
1.
Prepare the ingredients or the mixture according to the recipe. Fill these into the inner pot
and insert the inner pot into the housing. Please make sure that all ingredients, including li-
quids, are below the maximum mark (10 Cup) on the inner surface of the inner pot. Make sure
that the inner pot is firmly in contact with the heating element.
2.
Close the lid until it clicks into place. Connect the appliance to the power outlet.
3.
Press the ›Menu‹-button or the › + ‹ and › – ‹-buttons to select the program ›Multicook‹. Once
›Multicook‹ flashes on the LED-display the program is selected. (The pre-set cooking time is 30
minutes, the preset cooking temperature is 100 °C.) The LED-display shows the default values
for the temperature and cooking time.
4.
Use the ›Timer / t °C‹-button to reach the time selection mode. The minute indicator flashes.
Use the › + ‹ and › – ‹-buttons to adjust the time. With the ›Hour / Min‹-button you can switch
between hours and minutes. The LED-display shows the pre-set cooking time 30 min. You can
adjust the cooking time from 2 minutes to 15 hours.
5.
Press again the ›Timer / t °C‹-button to adjust the temperature. The temperature indicator
flashes. The LED-display shows the pre-set temperature 100 °C. Use the › + ‹ and › – ‹-buttons to
select the desired temperature.
6.
If necessary, adjust the Auto-Start-Function to start cooking later.
7.
Press and hold for a few seconds the ›Start / Keep Warm on / off‹-button to start the appli-
ance. The ›Start / Keep Warm on / off‹-button lights up and the countdown of the cooking time
is shown in the time indicator.
8.
The Keep-Warm-Function turns on automatically, immediately after the program is over, if
the selected temperature was over 75 °C. If necessary, this function can be switched off by
pressing and holding the ›Start / Keep Warm on / off‹-button at any time.
9.
After completion of the program an acoustic signal will sound. Depending on the settings of
the appliance, the Keep-Warm-Function will launch (the LED-display counts up the time) or the
appliance will return to standby mode.
10.
To cancel the selected program, to interrupt the cooking process or the Keep-Warm-Func-
tion press and hold the ›Cancel / Keep Warm‹-button for a few seconds.