60
61
Disassembling the blender jug and removing stubborn residues
waRNiNg:
The blade is very sharp! Do not touch the blade. To handle the blade, always
hold on to the blade assembly housing.
1.
Remove the blender jug off the motor block and hold it over the sink or a large bowl. Turn
the blender jug upside-down. The underside of the knife unit is now up. Grasp with the left
hand the handle of the blender jug and with the right hand the plastic holder of the knife unit.
Remove the knife unit by turning it counter-clockwise. Take the knife unit off the blender jug.
attENtioN:
The blender jug might be connected really tight to the holder. Do not use force
unscrewing it.
2.
Rinse all parts in warm soapy water. Soak stubborn residues for a few minutes and then
remove them using a nylon washing brush or sponge. Do not cut yourself. Beware not to dam-
age the silicone seal. If you can not get the sealing ring clean or if it is porous or damaged
you have to replace it. Contact your vendor for replacement parts.
3.
After cleaning rinse all parts with clear water and dry them carefully. You can also leave
all parts dry naturally where they are out of reach of young children. When the parts are dry
assemble the blender jug for storage or usage.
Cleaning the motor block
waRNiNg:
Do not
place the motor block in an automatic dishwasher or pour boiling
water over it. Do not immerse the motor or power cord in any liquids or spill any liquids on it
or place the motor on wet surfaces. Always wipe off spilled liquids immediately. Ensure that
no water can run into the louvre. When liquids are spilled on the motor housing, immediately
unplug the appliance and dry the motor housing to avoid risk of electric shock or fire.
Do not
attempt to operate the appliance, when liquids are on or in the motor housing.
1.
Always turn the appliance off, wait for the motor to stop completely, and unplug the appli-
ance from the power outlet before you start cleaning the moto rblock.
2.
Wipe the motor housing and power cord with a damp soft cloth. Take care not to spill or
drip water or any other liquids on the motor housing.
attENtioN:
Ensure not to damage the drive gear. Never poke with anything into the motor-
block. If necessary use a soft brush for cleaning. If any liquids run into the motorblock clean
and dry the motorblock very carefully.
3.
Thoroughly dry the motor block after each cleaning or leave it dry naturally where it is out
of reach of young children. Afterwards assemble the appliance.
attendance:
You do not need to oil the motor. Clean the parts only as described in the
instructions.
waRNiNg:
Return the entire appliance to an authorised service centre for examination
and repair.
