© 2011 Gastech Australia Pty Ltd
Page 8
3.
Mounting
Install the Control Unit into an enclosure with sufficient space around it to allow heat dissipation, as shown
below.
DIN Rail Mounting:
When mounting the control unit to 35mm DIN rail, be sure to use the retaining clip to stop
any side-to-side movement of the unit and reduce the chance of wires becoming loose. The retaining clip is at
the bottom of the housing. To secure the controller to DIN rail, pull down the clip, place it onto the rail and
gently push it up. To remove the unit, pull the retaining clip down with a flat screwdriver and gently remove it
from the DIN rail.
The optional HMI unit is designed for panel mounting. A mounting kit with gasket is provided to allow a proper seal
to be made around the mounting hole. Dimensions for the rectangular cut-out are given in the diagram below.
