gassero Wallcon X-treme 67, Installation And User Manual

Page: 39 / 44


Water, gas, air, chimney and electrical connections will be checked.
 Gas leakage control will be made. For gas leakage control, a gas
detector or leakage detection sprays may be used.

Chimney connections will be checked for leakage of gas or
condensation water.

If there is an air inlet filter in the boiler, it will be checked and replaced
if necessary.
 Electrical connections, sockets, grounding terminals will be checked.

Automatic air relief valves, thermometers, manometers or similar
control devices in the system will be checked, if any issues detected
installation / mechanical service will be warned.
 After the boiler has been switched on, the burner must be checked
with the analyzer and the emission settings will be re-made if
necessary.

Time / holiday settings which are made according to the requests of
the consumer will be checked.
 Emission values (CO2 and O2) will be written to the service document
by operating the boiler at nominal, minimum and partial load.
13 ENERGY SAVING RECOMMENDATIONS

INSULATION: Building insulation is one of the most important steps of
energy saving. Insulated building allows you to get more energy using
less fuel.
 ADJUSTING RIGHT TEMPERATURE VALUES: Selecting
COMFORT and REDUCED TEMPERATURE values will save energy.
Excessively selected COMFORT temperature will increase the energy
consumption. To save more energy use REDUCED TEMPERATURE
function more often.
 CORRECT PROGRAMMING: Selecting the correct operation ranges
for automatic mode will save energy.

INSTALLATION INSULATION: Insulation of pipes, collectors, boilers,
storage tanks and chimneys in the boiler room saves energy.
Installation pipes which will pass through unused spaces must also be
insulated.
 WATER QUALITY: Water treatment will keep the water conditions
under constant control and saves energy.

REGULAR MAINTENANCE: Maintenance of the boiler once a year
and reviewing the system periodically is also important for energy
saving.
38
14 DISPOSAL

When WALLCON X-treme boilers have to be disposed of, the
procedures determined by the local authorities must be followed.
Such wastes must be treated in accordance with the applicable
regulations.

Similarly, local regulations will be followed for the packaging wastes.
Leaving the non-functional units, spare parts and
packaging materials in the environment and leaving
them accessible to children can be dangerous.
Such wastes must be treated in accordance with the
applicable regulations.
Ignoring this warining may harm, people, animals
and may cause property damage. Manufacturer is
not liable for damages that may arise in such cases.