Gaspardo PENTA PE 300, Use And Maintenance

Page: 40 / 134

USE AND MAINTENANCE
40
ENGLISH
cod. 19501163
g
3.2.5 SEEDER POSITION
It is important to adjust the position of the planting unit correctly
on the supporting equipment when in the field.
DANGER
Positioning the seeder on the equipment is an extremely
dangerous phase. Proceed with extreme caution and carry
out the operation scrupulously adhering to the instructions
provided.
1) Before positioning the seeder, it is important to place the
equipment in the position in which it is to operate.
2) Adjust points (A) and (B) Fig. 18 of the planting unit so that the
seeding element support bar is at a height of approx 45 to 50
cm from the ground (Fig. 20), and at the same time does not
interfere with the rear roller of the equipment
ATTENTION
If the operating position of the equipment needs to be changed,
re-position the seeder by proceeding as described earlier in
point 2).
3) Connect and secure the seed delivery tubes to the furrow
opening parts with the ring provided (Fig. 19), and check their
length: during the work the formation of loops and folds, and
therefore breakages, should be avoided. If necessary adjust
their length as shown in Figure 20.
45
÷
50
cm
A
B
fig. 18
fig. 19
fig. 20
cod. 19702620
12345678901234567890123456789012123456789012345
12345678901234567890123456789012123456789012345
12345678901234567890123456789012123456789012345
45÷50 c
m