Gaspardo MCE 6000, Use And Assembly Instructions / Spare Parts

Page: 11 / 72

USE AND MAINTENANCE
ENGLISH
25
-
cod. G19502283
5.5.2 EXCLUSION OF THE ROWS OF SEEDS
& (
& X
A ) in order to exclude
ON %ΠEXCLUDED ;
OFF %ΠASSETS .
A
Es.: Row number excluded 2 and 3.
` <_ $"^ -
are excluded.
several switches are ON (row excluded) and prevent some sections
ˆ|&
0.0 Km/h and there are no other alarms relating to planting present,
the monitor will emit 2 short close sound signals every 15 seconds.
All the alarms relating to planting have priority with respect
to this function
.
5.5.4 SELECTING AND RESETTING THE QUANTITIES SHOWN
ON THE DISPLAY
>
1) Speed (km/h).
2) Tilled area (Ha), partial and total counter.
3) Seed planting distance (cm)
(°) .
’[ V X [ (°) .
(°) IMPORTANT!! Size not displayed if the “Passage Mode” is selected
(see par. 5.4). Value «0» is displayed.
!‘
K
J
H
I
In particular, the distinction between partial and total area counter
‰^+
Š‹>
the right indicates the total count.
ˆ
XŠ(((‹[
' X(Š;(((‹[
Rows 10, 11 and 12 will be indicated on the display with just the
second digit (namely 0, 1 and 2) lit intermittently.
To stop the display cycle and stay on a chosen row, press button
Š‹
Š‹
also applied to the planting density: the average is indicated with
ŠV(((‹ Š;(((‹Š<(((‹
Š‘‹
mode, press it again.
The quantities that can be reset to zero are the counters; to carry
' &Š%Œ^)^‹ XŠ^‹[
the reset value appears on the display.
It is also possible to reset the counter to zero by pressing the “-
Œ^)^‹ XŠ^‹[
E
* In case “4” the seed planting irregularity is caused by failure to disable a row, which could be due for example to a possible mechanical problem on
the disabling device.
** In case “6” two types of sound are distinguished: intermittent with seed planting distance outside the set tolerance (parameter S); continuous sound
with seed planting distance equal to zero, caused by the absence of signal from the photocell. Signal absence could be due for example to there
being no seeds left in the hopper or clogging of the distributor.
*** See Chapter 5.5.2.
Monitor status
(led rif. C)
Row switch status
(rif. A)
Row LED status
(rif. B)
1
2
3
4
5
6
7 Out (OFF)
Out (OFF)
Lit up (ON)
Lit up (ON)
Lit up (ON)
Lit up (ON)
Lit up (ON) OFF
ON (disabled row)
ON (disabled row)
ON
OFF
OFF
OFF with speed = 0km/h Out
Flashing
Steady lit
Flashing
Out
Flashing
Flashing
Seed planting
irregulary present?
Irrelevant
Irrelevant
NO
YES *
NO
YES
NO
Buzzer status
Silent
Silent
Intermittent active ***
Intermittent active
Silent
Active **
Silent
Table 3
5.5.3 MANAGEMENT OF VISUAL AND AUDIO ALARMS:
MCE 6000/12000 uses visual (LEDs) and audio (buzzer located
& [
that can occur during the work. See table 3 below.