background image

Gas Installation Codes

•    Appliance must be used in accordance with the 

installation requirements of your gas supply authority,  
or the appropriate installation code issued by Standards 
Australia AS 5601.

•    Appliances for use with bottled gas are labelled  

‘propane gas’.

•    Only use on a non-combustible surface.

Clearances

Minimum Clearances from combustible materials must be: 
Cylinder - 500mm.  Wall - 500mm.  Above - 1200mm. 
Below - never use on a flammable surface. Only use on a 
non-combustible surface.

Hose & Regulator Safety

The regulator and hose assembly supplied with the 
appliance are suitable for propane gas only.  
The pressure regulator and hose assembly supplied 

with the appliance must be used. Replacement pressure 

regulators and hose assemblies must be those specified 

by the appliance manufacturer.
Only use the hose assembly supplied with this appliance 
for direct connection to the cylinder 
“DO NOT USE ADAPTORS”. 
Check the regulator “O” Ring periodically for wear or 
damage and replace if required.
When connecting the hose and regulator assembly to the 
gas cylinder, take care to avoid unnecessary twisting or 
kinking of the flexible hose. Maximum hose length is 1 
metre.

•  Outdoor use only.
• 

Read these instructions for use carefully.  

 

  Familiarise yourself with the appliance    

 

  before connecting it to its gas container.  

 

  Keep these instructions for future reference.
•  Failure to comply with these instructions could  
  result in a fire or explosion which could cause  
  serious bodily injury, death or property damage. 
 

CAUTION: Accessible parts may be very hot.

•  Keep young children away.
•  DO NOT modify this appliance.
•  DO NOT move this appliance during use.
•  Turn off the gas supply at the gas cylinder after use.
•  Parts sealed by the manufacturer or their agent must    
  not be manipulated by the user.
•  This appliance is only to be used outdoors.

•  Never operate this appliance without a regulator.
•  Do not test for gas leaks with an open flame.
•   If this information is not followed exactly a fire causing  

  death or serious injury may occur.  

•  Do not store a spare gas cylinder under or near this    
  appliance. Never fill the cylinder beyond 80% full. This  
  appliance is only to be used and stored outdoors.
•   If there is a leak on your appliance (smell of gas),  

 

  immediately attempt to turn off the cylinder valve.  

 

  Remove the appliance to a well ventilated   

 

  location away from any ignition source. Only check    
  for leaks outdoors using soapy water. DO NOT try to    
  detect leaks using a flame. 

•   Never connect an unregulated gas cylinder to your 

appliance.

NOTE: ONLY USE ON A NON-COMBUSTIBLE SURFACE

2

After the assembly has been secured, turn on the gas and 
check for leaks by brushing a soap and water solution 
overall connections. 
DO NOT USE this appliance if it is leaking, damaged or 
does not operate properly.
If you are unable to correct the leak by tightening the 
connections, turn off the gas and contact the supplier 
immediately.
Always ensure the appliance is kept away from flammable 
materials and the gas cylinder clear of any heat source. 
When changing over from an empty gas cylinder to a 
full one make sure this procedure is carried out in a well 
ventilated location, preferably outside, away from people 
and away from any sources of ignition; such as naked 
flames, pilot flames, electric heaters/equipment.

Specifications

Appliance specifications can be found on the data label 

attached to the appliance body.

Gas Cylinder Use & Safety

This is a low pressure appliance and must only be used 

with the hose and regulator supplied.  This appliance shall 

only be used with propane gas cylinders certified to AS 

2469.  It may be hazardous to attempt to fit other types of 

gas containers.
The gas cylinder should be filled by a reputable gas 
supplier and visually inspected and re-qualified at each 
filling.
Always keep cylinder in an upright position. Always close 
the cylinder valve when the appliance is not in use.
Do not subject gas cylinder to excessive heat.

GENERAL INFORMATION

IMPORTANT

Summary of Contents for RB2









Reviews: