HEATER ASSEMBLY & PARTS LIST
Tools Required:
Phillips head screwdriver
2 adjustable spanners
Note:
Remove all transit protection
material.
Step 1.
Secure the base to the cylinder cover
body with nine M6 x 15 mm long screws
with washers and nuts, ensuring the base
detent is at the front left corner. Secure
the wheels with three M6 x 15mm long
screws with washers and nuts.
Step 2.
Secure the post onto the post frame with
four M6 x 15mm long screws with washers
and nuts.
Step 3.
Slide the decorative post cover down the
post onto the cylinder cover body.
Step 4.
Fit the door with the spring hinge pin at
the top.
Step 5.
From inside the cylinder cover feed the
hose up through the post and temporarily
secure the end with tape to the post top.
Step 6.
Securely attach the hose connection
adapter supplied to the burner head gas
pipe.
Step 7.
Securely attach the hose to the burner
head. Temporarily attach the gas cylinder
and check the connection for leaks using
a soap solution. Clip the cylinder retention
strap into position either side of the door.
Step 8.
Secure the burner head assembly to the
post with four M5 x 8mm long screws.
Step 9.
Secure the reflector to the burner
assembly with four M6 x 8mm long screws
and washers.
