Gasmate ONYX GM142-175, Manual

Page: 4 / 12

5 4
GENERAL ASSEMBLY
Connecting & Disconnecting to Gas Source
Familiarise yourself with the general information and
safety guidelines located at the front of this manual.
Check:
1. The cylinder is filled. A sloshing sound will be heard
when shaken.
2. The control knob is in the ‘OFF’ position.
Connecting
1. Ensure cylinder valve is in its full off position.
2. Check for any damage to either the cylinder
connection or the hose. NEVER attempt to use
damaged equipment.
3. When connecting the hose to the cylinder tighten the
nut to a positive stop by hand.
4. Open cylinder valve fully. If a leak can be heard at
either end of the hose, turn cylinder off and tighten
joint. Wait 5 minutes before re-testing and use a
soapy water solution to check the joint. If bubbles
appear the connection will need to be re-tightened.
Refer to page 6 for more detailed instructions on
connecting the appliance to the cylinder.
Disconnecting
1. Ensure the burner control is in the ‘OFF’ position.
2. Ensure cylinder valve is in the full off position.
For storage and cylinder exchange, disconnect hose
at the cylinder only, DO NOT disconnect hose from
appliance.
IMPORTANT: Before connecting and
disconnecting appliance to gas source,
make sure control knob is in ‘OFF’ position.
CAUTION: When the appliance is not in use,
the gas must be turned off at the cylinder.
QCC CYLINDER CONNECTION DEVICE
Screw the coupling nut of regulator into the cylinder valve
outlet.
Type of Gas I3/P28-30/ULPG
Consumption 21.1MJ/h
Operating Pressure 2.75kPa
Injector Size 1.10 mm
Heater specifications can be found on the data label.