17
16
GEnERAl ASSEmBlY
Connecting & disconnecting to Gas
Source
Familiarise yourself with the general information
and safety guidelines located at the front of this
manual.
Check
1. Gas cylinder is filled. A sloshing sound will be
heard when shaken.
2. The burner control is in the ‘OFF’ position.
Connecting
1. Ensure valve is in OFF position.
2. Check for any damage to the cylinder
connection. NEVER attempt to use damaged
equipment.
3. When connecting the hose to the cylinder
tighten the nut to a positive stop by hand or
spanner.
4. Open cylinder valve fully. If a leak can be
heard at either end of the hose turn cylinder
off and tighten joint. Wait 5 minutes before
re-testing and use a soapy water solution to
check the joint. If bubbles appear the
connection will need to be re-tightened.
disconnecting
1. Ensure the burner control is in the ‘OFF’
position.
2. Ensure the gas cylinder is in the full OFF
position.
3. Detach the hose from cylinder.
lIGHTInG PRoCEdURE
Burner operation & Ignition System
Check
1. With cylinder valve in ‘OFF’ position push and
turn the control knob anti-clockwise to HIGH.
Check for sparking to the burners.
2. If spark is not evident at the burner ignition
point, check for any loose leads at either the
electrode or the gas valve.
3. Push and turn anti-clockwise to HIGH a control
knob on either side of the igniter button whilst
pushing the button, subsequent burners will
crosslight.
4. The side burner cover must be open before
pushing and turning the control knob anti-
clockwise to HIGH.
5. If the burner fails to light after several
attempts turn off the gas supply and
inspect for any obstructions to the gas flow.
If re–ignition is necessary while the gas barbecue
is still hot, you must wait for a minimum of 5
minutes before commencing to re–ignite (this
allows accumulated gas fumes to clear).
• IMPORTANT: Before connecting and
disconnecting barbecue to gas source,
make sure burner controls are in ‘OFF’
position.
• CAUTION: When the barbecue is not
in use, the gas must be turned off at the
cylinder.
• Check that the seals between the
appliance and the gas cylinder
are in place and in good condition
before connecting the gas cylinder.
• Do not use this appliance if it has
damaged or worn seals.
• NOTE: If for some reason, ignitor fails to
produce a spark at the electrode, BBQ
can be lit by a long BBQ match. With hood
open insert ignited match into burner
lighting hole positioned on the right hand
side of the BBQ body (underneath
side shelf). Push and turn the far right
control knob to HIGH. Burner ignition can
be checked through this hole. Subsequent
burners will cross light.
• Check performance of burner prior to
installing BBQ plates.
• Do not smoke when attempting to ignite
BBQ.
• Never use volcanic rock, heat beads or
other material.
• Always use protective gloves when
handling hot components.
ImPoRTAnT
ImPoRTAnT
Summary of Contents for Horizon BQ8401
Page 6: ...6 BQ8401 EXPLODED DIAGRAM ...
