Gasmate GM160-014, Manual

Page: 4 / 20

4 5
GENERAL ASSEMBLY
Regulator Safety Feature
All QCC regulators (the part that attaches to the gas
cylinder to regulate the flow of gas) have a safety feature
included that restricts gas flow in the event of a gas leak.
You can inadvertently activate this safety feature without
having a gas leak. This typically occurs when you turn
on the gas using the appliance control knob before you
turn on the gas cylinder valve. If the gas regulator safety
feature activates, the appliance will operate with reduced
output as gas flow is restricted.
These steps should be taken first to reset the gas regulator
safety device:
1. Ensure the appliance door is open.
2. Turn gas cylinder valve off.
3. Turn off all control knobs.
4. Disconnect the regulator from the gas cylinder.
5. Wait 30 seconds.
6. Reconnect the regulator to the gas cylinder.
7. Leak test the connection using a soapy water solution.
Ensure no bubbles appear before proceeding.
8. Slowly open the gas cylinder valve all the way. Do not
put excessive force on the valve at the full open
position, to avoid damaging the valve.
9. Light appliance as per the instructions provided.
LIGHTING PROCEDURE
Before lighting your appliance for the first time, read the
instructions fully to ensure the appliance is assembled
correctly and is ready for use.
Remove all point-of-sale material from the appliance.
Burner Operation & Ignition System Check
1. Open the door of the appliance before attempting to
light the burner.
2. Turn the control knob clockwise to “OFF” position.
3. With cylinder valve in ‘OFF’ position press the electronic
igniter button (a clicking sound is heard). Check for
sparking to the burner.
4. If spark is not evident at the burner ignition point,
check that the ignition lead is firmly attached to the
control and sparker tip.
5. With sparking established turn the cylinder valve ‘ON’.
6. Push and turn the control knob anti-clockwise to ‘HIGH’
and press the igniter button again.
7. If the burner fails to ignite after several attempts turn
off gas supply at cylinder valve and the control knob off
(clockwise). Wait five minutes before attempting to
relight with ignition sequence.
8. Following successful ignition, adjust the heat by turning
the control knob to the “HIGH”/”LOW” position.
9. To turn the appliance ‘OFF’ turn the cylinder valve to
the ‘OFF’ position, then turn the control knob on the
appliance clockwise to the ‘OFF’ position.
IMPORTANT:
• Before connecting and disconnecting appliance to
gas source, make sure control knob is in ‘OFF’
position.
• Caution: When the appliance is not in use, the gas
must be turned off at the cylinder.
• Check performance of burner prior to installing
ceramic stone.
• Do not smoke when attempting to ignite appliance.
• During use the side and top surfaces will be hot.
• Always use protective gloves when handling hot
components.
• Note: If for some reason, ignitor fails to produce a
spark at the electrode, appliance can be lit by a long
barbecue match. With door open insert lighted
match into the gap in front of the ceramic stone.
Push and turn control knob to ‘HIGH’. Burner ignition
can be checked through this gap.
• If re–ignition is necessary while the appliance is still
hot, you must wait for a minimum of 5 minutes
before commencing to re–ignite (this allows
accumulated gas fumes to clear).