4
assembly
For additional protection the installation of a
residual current device (RCD) is advisable.
1. Remove all package material (including
anti-vibration protection of the lamp) and check
the appliance, supply cord and the plug for
signs of damage.
2. Ensure the mounting location and all mounting
materials are suitable and strong enough to
support the appliance.
3. Before mounting, the minimum safe mounting
distances and tilt angles shown in the figures
must be strictly followed.
The distance between the bottom edge of the
appliance and the floor must be at least 1.8 M.
There must be a distance of at least 0.5 M
between the appliance and the ceiling, roof or
other covers.
There must be a distance of at least 1.5 M at each
side between the appliance and walls or the like.
See figure 2.
Recommended degree to mounting surface is 45°.
See figure 3.
4. Fix the mounting bracket to the wall first.
Ensure that the location it is to be installed is
secure and firm.
5. Adjust the desired angle of radiation and
tighten all screws.
7. Plug into the power source and check operation.
Figure 1.
Mounting bracket
(wall bracket)
and anchor
dowels provided.
Connection from
the wall to
the infrared
heater.
Figure 2.
Min. distance to
floor,ceiling and
wall
Figure 3.
Tilt angle.
tHIs HEatEr Is suItaBlE For
Wall MouNtING oNly.
Electrical Data
IMPortaNt
This product is fitted with a sealed electrical connection plug that is compatible with the heater, the mains
supply for Australia and meets the requirements of international standards. This heater must be connected to
a supply voltage that is equal to that stated on the rating label. If the mains connection plug or power cord
becomes damaged it must be replaced with a complete assembly that is identical to the original, and this must
be replaced by an authorised service centre. Always follow the Australian requirements for connection to the
mains supply. If in doubt always consult a qualified electrician.
tEcHNIcal sPEcIFIcatIoN
Model Number
Voltage
Input Wattage
unit Weight
unit size (W x H x D)
EH515
220-240V AC 50Hz
1300W
2.3Kg
450 x 100 x 120mm
EH520
1500W
2.5Kg
540 x 100 x 120mm
EH525
2000W
2.8Kg
670 x 100 x 120mm
Heater specifications can be found on the data label.
