5
4
NOTE: Remove any transit protection material
1. Place metal cover ‘A’ over weighted base ‘C’.
2. Push bottom pole ‘D’ into completed base ‘A+C’
and secure using screw ‘B’. Screw ‘B’ goes through
completed base ‘A+C’ and into the bottom pole ‘D’,
tighten fully.
3. Loosen and remove 2 screws ‘L’ on pole ‘D’ and slide
pole ‘E’ onto pole ‘D’. Re-fit and tighten fully the 2
screws ‘L’.
4. Repeat step 3 for pole ‘E’.
5. a) Loosen and remove collar ‘G’ from pole ‘F’.
b) Remove screw from pole ‘H’.
6. Push small pole ‘H’ up through the centre of pole ‘F’,
ensure pole ‘H’ is fully through the other end of pole
‘F’.
7. Re-fit and tighten collar ‘G’ onto pole ‘F’.
8. Place heater head onto pole ‘H’ and tighten screw ‘I’.
9. Clip power cord into all cord clips ‘K’.
Heater is now complete and ready for use.
To Tilt Head
Note: Always ensure that the heater is switched
off, disconnected from the mains power supply
and is cold to touch. If heater has been recently
used, please leave the heater one (1) hour to
cool before tilting head.
1. Loosen the head tilt screw, do not remove.
2. Head can be tilted through 10°.
3. Tighten the head tilt screw when the desired angle is
achieved.
I
H
G
F
E
D
C
B
A
K
J
L
L
K
J
J
K
Assembled heater head
Head tilt screw
Fitted
power cord
& plug
Completed height on stand
1.7m
Fitted
pull cord
for use
Head tilt screw
10
0
STAND ASSEMBLY
