3
2
INSTALLATION, OpERATION AND
MAINTENANcE INSTRUcTIONS
Safety
Before attempting to operate this smoker, the
following basic safety precautions should be
taken to reduce the risk of fire, electric shock
and personal injury. It is important to read
the instruction manual and to understand its’
applications, limitations and potential hazards
associated with this smoker. This smoker is not
intended for use by persons (including children)
with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning the use of the appliance by
a person responsible for their safety. This smoker
is not designed for use within 1m or above a water
source. It is important that you read, understand
and follow these instructions very carefully. They
are designed for the safety of yourself and others
ensuring a long and trouble free service life from
your smoker. This electric smoker complies with
Australian and International standards and safety
requirements. Repairs should only be carried out
by qualified persons using original spare parts.
Failure to do so may result in considerable danger
to the operator.
Safe Operation
Beware of children and pets
Children should not be allowed to touch or
operate smokers or touch extension cords, if
used. All smokers should be kept out of reach of
children, preferably stored or locked in a secure
cabinet or room when not in use.
Do Not Abuse the power cord
Never yank or pull on the power cord to disconnect
it from the mains supply socket. Never carry your
smoker by its’ power cord. Keep the power cord
away from heat, oil, solvents and sharp edges.
Check the power cord regularly for any damage
and if the power cord becomes damaged have it
replaced by an authorised service facility.
Extension cords and Reels
This smoker is NOT designed to run off an
extension cord. If you require an additional power
point please have one installed by a qualified
electrician.
The use of extension cords may cause power
voltage loss which will result in damage to
the appliance this will NOT be covered under
warranty.
Installation
The electrical system of this smoker must be
connected with an automatic 30mA circuit breaker
and/or residual current device (RCD). If uncertain
have a qualified electrician check your electrical
system before installation and/or use.
All electrical connections are made in a dry area.
This smoker is not designed for use within 1m or
above a water source. All installations must meet
the requirements of Australia Standard
AS/NZS 3000:2007.
Ensure that the smoker is not positioned directly
above, below or in front of a power point or
switch.
This smoker is not designed to be used with 3rd
party timer or programmable system.
