5
4
GENERAL ASSEMBLY
Connecting & Disconnecting
to the Gas Source
Familiarise yourself with the general information
and safety guidelines located at the front of this
manual.
Check:
1. The cylinder is filled. A sloshing sound will be
heard when shaken.
2. The burner controls are in the ‘OFF’ position
Connecting:
1. Ensure cylinder valve is in its full off position.
2. Check for any damage to either the cylinder
connection or the hose. NEVER attempt to use
damaged equipment.
3. When connecting the hose to the cylinder
tighten the nut to a positive stop by hand
or spanner.
4. Open cylinder valve fully. If a leak can be heard
at either end of the hose turn cylinder off and
tighten joint. Wait 5 minutes before re-testing
and use a soapy water solution to check the
joint. If bubbles appear, the connection will
need to be re-tightened.
Disconnecting:
1. Ensure the burner control is in the ‘OFF’
position.
2. Ensure cylinder valve is in the full off position.
For storage and cylinder exchange, disconnect
hose at the cylinder only, DO NOT disconnect
hose from appliance.
LIGHTING PROCEDURE
Burner Operation & Ignition
System Check
1. Turn the control knob clockwise to “OFF”
position.
2. Connect the regulator to the gas bottle. Turn
the gas supply “ON” at the cylinder. Check
with the use of soapy water for any gas
leakage between the bottle and the regulator
3. Open the door then push down the control
knob and keep pressing whilst turning anti-
clockwise to the “HIGH” (a clicking sound is
heard), this will light the burner. If the burner
does not light,repeat this process.
4. If the burner still does not light, turn the control
knob to ‘OFF’ wait 5 minutes and repeat
step 3.
5. Adjust the heat by turning the knob to the
High/Low position.
6. To turn the appliance ‘OFF’, turn the cylinder
valve to the ‘OFF’ position and then the control
knob on the appliance clockwise to the ‘OFF’
position.
Problem: Burner will not ignite
Possible Reason
Solution
Valve on cylinder
is closed
Open valve on cylinder
Control knob is off
Turn knob to high
when lighting
Igniter is faulty
Use a long match
Ignition System Check
IMPORTANT
• Do not smoke when attempting to ignite
the appliance.
• Always use protective gloves when
handling hot components.
• Note: If for some reason, ignitor fails to
produce a spark at the electrode, appliance
can be lit by a long appliance match. With
door open insert lighted match into match
lighting hole positioned on the side of the
burner chamber. Push and turn control
knob to ‘HIGH’. Burner ignition can be
checked through this hole.
• The door must be in the open position
for lighting.
• Do not leave the appliance unattended
when alight.
