2
3
Screw the coupling nut of regulator into the cylinder valve outlet.
Q.C.C. CYLINDER CONNECTION DEVICE
Screw the coupling
nut of regulator
into the cylinder
value outlet.
7. The hose assembly should be properly located out of
pathways where people may trip over it. The hose
must be protected from contact with hot or sharp
surfaces both during use and while in storage. The hose
assembly should be visually inspected prior to each use
of the appliance. If excessive abrasion or wear is
evident, or the hose is cut, it must be replaced prior to
operating the appliance. The replacement hose
assembly may be obtained from the distributor.
8. DO NOT use any pressure regulator or hose
assembly other than those supplied with the appliance.
Replacement pressure regulator and hose assembly
must be those specified. Replacement parts may
be obtained from the distributor.
9. Installation and use of this appliance must conform with
New Zealand Standard 5601 “Gas Installations”.
10. This appliance is designed to operate with a standard
9Kg LPG cylinder with Approved Cylinder Connection.
11. The valve outlet must be maintained in good condition.
When the cylinder is not in use, be sure to cover it with
a dust cap. A leak test should be performed with soapy
water whenever connecting a new cylinder. NEVER use
a flame to test for leaks.
12. The LPG cylinder must be turned off whenever the
appliance is not in use. When the appliance is to be
stored indoors, the LPG cylinder and the appliance must
be disconnected and the cylinder stored in accordance
with LPG Dangerous Goods Regulations.
13. Store the appliance upright in an area sheltered away
from weather conditions. The use of a cover is
recommended.
Type of Gas
LPG/ULPG
Consumption
40.0 MJ/h
Operating Pressure
2.75 kPa
Injector Size
1.95 mm
Any modification to the appliance not described in the
installation instructions may compromise the safety of this
appliance. Special concern is as follows:
(1) DO NOT bypass thermocouple safety burner;
(2) DO NOT operate appliance without the guards;
Clothing or other flammable materials should not be hung
from the appliance, or placed on or near the appliance.
The area above the burner may be extremely hot.
Direct contact with these metal surfaces should be avoided
in order to prevent burns or clothing ignition.
Appliance specifications can be found on the data label.
14. The appliance has been designed with several safety
features which include a tip over switch and a flame
safeguard system which means if the pilot goes out the
unit will automatically turn off.
REGULATOR SAFETY FEATURE
All QCC regulators (the part that attaches to the gas cylinder
to regulate the flow of gas) have a safety feature included
that restricts gas flow in the event of a gas leak. You can
inadvertently activate this safety feature without having a
gas leak. This typically occurs when you turn on the gas
using the appliance control knob before you turn on the gas
cylinder valve. If the gas regulator safety feature activates,
the appliance will operate with reduced output as gas flow is
restricted.
These steps should be taken first to reset the gas regulator
safety device:
1. Turn gas cylinder valve off.
2. Turn appliance off.
3. Disconnect the regulator from the gas cylinder.
4. Wait 30 seconds.
5. Reconnect the regulator to the gas cylinder.
6. Leak test the connection using a soapy water solution.
Ensure no bubbles appear before proceeding.
7. Slowly open the gas cylinder valve all the way. Do not
put excessive force on the valve at the full open
position, to avoid damaging the valve.
8. Light the appliance as per the instructions provided.
Summary of Contents for Blaze
Page 12: ...12 ...
