16
17
EN
Frequently Asked Questions
EN
Technical Data
If you are not satisfied with the results, we hope that the following will
answer your questions and problems.
How do I switch the GASLIGHT
®
on and off?
+ You can install a standard switch between the required 12 / 24 Volt line.
Important: The switch must not be located in the gas bottle locker.
+ You can take the required 12 / 24 Volt from the light control of your
caravan. This will mean that the GASLIGHT® will light up as soon as you
switch on the light inside your caravan.
What do I do if one or more of the LEDs on the GASLIGHT
®
malfunctions?
+ Never open the casing of the GASLIGHT®; contact our Service Desk.
Can I also use the GASLIGHT
®
outside my gas bottle locker?
+ Of course you do not have to install the GASLIGHT® in your gas bottle
locker. We provide an optional 230 Volt plug-in power supply unit for
installing your GASLIGHT® in a non-intrinsically safe area.
Can I also use the GASLIGHT
®
outdoors?
+ Because the GASLIGHT® is waterproof, you can also install it outdoors.
Please note that the power supply unit may not be installed outdoors
and must not come in contact with water.
Can I extend the cable between the light and the intrinsically
safe power supply unit?
+ The cable between the light and the intrinsically safe power supply unit
be extended to up to 13 meters (42.5 feet).
Can I use the light without the intrinsically safe power supply unit?
+ You can use the light without an intrinsically safe power supply unit using
a 5V DC supply. However, in this case the light should not be used in
areas where there is an explosion hazard.
GASLIGHT
®
Article No.
GL-6001
Light dimensions (LxWxH)
140.7 x 18.2 x 7.8 mm
Dimensions of intrinsically safe
power supply unit (LxWxH)
110.1 x 61.0 x 27.1 mm
Weight of lamp
85 g
Weight of intrinsically safe power
supply unit (LxWxH)
72 g
Input voltage for power supply unit
10 - 30 V DC
Maximum input current for power
supply unit
350 mA
Output voltage of intrinsically
safe power supply unit
4,7 V +- 5 %
Short-circuit current for intrinsically
Safe power supply unit
< 2 A
Input voltage for light
4.0 - 5.5 V
Input current for light at 5 V
400 mA
Maximum power supply for the light with
an intrinsically safe power supply unit
10 m
Light intensity
160 lm
Test mark
Power-supply unit: EX
®
II (2)G [Ex ib Gb] IIB
Light: EX
®
II 2G Ex ib IIB T4 Gb
