Power on and clock interface displays, the corresponding clock flashing bar
flashes, touch and to set the clock Alarm clock function: Touch to make
the corresponding flashing bar on the display window flash to the corresponding
position . Touch and to decrease or increase the time. After setting the
time and flashing for 5 seconds, start timing, the flashing bar is on and the display
interface shows the remaining time. If the user needs to set the time for 30
minutes, set the alarm time to 30 minutes.
Stop function: Touch to make the corresponding flashing bar on the display
window flash to the corresponding position . Touch and to decrease or
increase the time, setting the time and flashing for 5 seconds, automatically return
to the clock interface to start timing, the flashing bar is on, and the display inter-
face shows the clock time. If the user needs to set the time for 30 minutes, set the
alarm time to 30 minutes.
End function: Touch to make the corresponding flashing bar on the display
window flash to the corresponding position . Touch and to decrease or
increase the time, setting the time and flashing for 5 seconds, automatically return
to the clock interface to start timing, the flashing bar is on, and the display inter-
face shows the clock time. Note: The end function needs to be used in conjunc-
tion with the clock, that is, the end function needs to be greater than the clock
time. If the user needs to time for 30 minutes and the current clock time is 12:00,
then the end time needs to be set to 12:30.
Default Timing Time Setting: Press and hold for 3 seconds to enter the default
2-hour timing state. The display shows the timing remaining time. The flashing bar
will cycle. When the timing time is up, buzzer rings and relay off. Press and hold
for 3 seconds again halfway then timing function can be cancelled.
Switching between 12-hour and 24-hour System:
Under clock state, press and at the same time to enter the 12-hour and
24-hour system switching interface. Press , display interface displays 12 ,
switch to 12-hour system. Press , display interface displays 24, switch to
24-hour system. After setting, press or after 5 seconds, it will return to the
clock interface automatically.
Important: In the above timing function, the timer does not control the ON,OFF
and heating of the oven. The timer is only a buzzer reminder. If the oven heating
needs to be stopped, you need to manually turn off the valve to shut off the gas
then to turn off the oven heating.
06
www.gaslandchef.com
8350 Patriot Blvd STE B, N. Charleston, SC 29418
1 (844) 538-7890
