GASLAND chef AS150, Installation Instructions Manual

Page: 42 / 60

7. Turn on your water output device to the “on” position and adjust to the desired
water flow.
8. There will be a series of audible clicks and the burner will ignite. Please take
note the water heater must not be exposed to flammable vapors or liquids
during lighting. Should the burner not ignite after 5 seconds, shut off and go to
the “Troubleshooting” section.
9.Upon completion of use or storage, open the drain valve (ribbed cylindrical
stem next to the water input valve) to ensure draining of water.
10.Turn off your gas supply.
12. WARNING: If the outside temperature is around or below freezing
(32 °F/0°C), ensure that the drain plug is opened and water drained from the
portable tankless water heater after each use to avoid internal damage to
the heat exchanger. You will also need to unhook the outgoing water line to
ensure that any water in the heat exchanger is drained. Failure to properly
drain your portable tankless water heater will cause water heater damage
which may or may not be reparable.
Before Operate The Drain Plug, Must be
1. Ensure that the water heater is disconnected from the gas supply.
2. Ensure that the water heater is disconnected from the water supply (turn off
cold water inlet switch).
3. Turn the shower switch to “ON”.
4. Ensure that the shower hose is disconnected from the water heater.
www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418 support@gaslandchef.com
1 (844) 538-7890
20