Gasboy Orpak M09680B136, Installation And Setting Instructions Manual

Page: 5 / 12

MDE-5262A Barcode Reader Installation and Setup Instructions · May 2016 Page 5
Installing OrPT Barcode Kit and Cover
Installing OrPT Barcode Kit and Cover
To install the OrPT Barcode Kit and cover, proceed as follows:
1
Turn-off the AC Power to the Islander
™
PLUS unit.
2 Unlock and open the Islander PLUS door assembly.
3
Remove all cable connectors.
4 Loosen the two wing nuts on the rear of the unit (see Figure 1 ).
Note: Retain the nuts for reuse.
Figure 1: Removing Cable Connectors
Wing Nuts (2X)
5
Remove the holder bracket.
6
Remove both the OrPT rear panels by releasing the seven screws that secure the covers

(see Figure 2 ).
Note: Retain the screws for reuse.
Figure 2: Removing Rear Panels