Gasboy C08951, Maintenance Manual

Page: 9 / 16

GASBOY Star Receipt Printer
2-2 03/20/03
STATUS BOARD LAMPS
Table 2-2. Status Board Lamps
Lamp Function
D1 +12
VOLTS
This lamp should be lit whenever SW1 (Power) is on.
D2 ON LINE
This lamp must be on to print receipts or do a self-test. If it is not on, momentarily press
SW4.
NOTE: This lamp does not have to be lit to feed paper (SW3).
D3 ALARM
This lamp will light when a mechanical failure occurs, or when the printer runs out of paper.
CONTROLLER BOARD DIP SWITCH SETTINGS
The controller board DIP switches are set at the
factory prior to shipment. For proper operation of
the printer, the controller board switch settings
should be as follows:
Table 2-3. Dip Switch Settings
SW1 Pos SW2 Pos
1-1 ON 2-1 ON
1-2 ON 2-2 ON
1-3 ON 2-3 ON
1-4 ON 2-4 OFF
1-5 OFF
1-6 ON
1-7 ON
1-8 OFF
NOTE: DIP switches are only read by the controller
at power up. DIP switch changes should
be made with the power off.
Figure 2-2. DIP Switches