13
2ZQHU¶0DQXDO
Basic Operation
1. Tuning the unit On / Off
Press any Button to turn the unit
on, the display will show a message
WELCOME TO CAR AUDIO to in-
dicate it is ready for use. Press and
hold the PWR button to turn the unit
off. The display will show a message
“GOODBYE”.
2. Mode Selection
Press the MOD Button to select Ra-
dio Mode. Press the MODE Button
to cycle the Play Mode amoung AUX,
RADIO and CD PLAY.
Note: USB & SD mode will only show
on the display when a USB flash
memory or SD card is inserted into
the USB port or SD portt.
3. Loudness Control
Press the SEL button until “LOUD
OFF” is shown on the display indi-
cates that the loudness function is
OFF. Turn the volume knob to select
between ON or OFF.
4. Mute Control
Press the POW/MUT button active or
cancel Mute function.
5. Volume
Use the VOL +/- Button to adjust the
volume level. The larger the number,
the higher the volume level.
6. Bass
Press the SEL Button repeatedly until
the display shows "BAS 00". Use the
VOL +/- Button to adjust. When EQ is
ON, bass control is not available.
7. Treble
Press SEL Button repeatedly until the
display shows "TRE 00". Use the VOL
+/- Button to adjust. When EQ is ON,
treble control is not available.
8. Balance
Press SEL Button repeatedly until the
display shows "BAL L-R", then use the
VOL +/- Button to adjust the balance
between the left & right speakers.
9. Fader
Press SEL Button repeatedly until the
display shows "FAD F-R", then use
the VOL +/- Button to adjust the bal-
ance between the front & rear speak-
ers.
10. Clock
The time clock can be set anytime
when the power is on. Press the PTY/
CLK Button on the faceplate or re-
mote control once, the time will show
on the display.
Then press and hold the button until
the hour blinks on the display. Rotate
the VOL knob to set hours, then press
the VOL knob for the minutes to blink
and rotate the VOL knob to set.
Press the PTY/CLK button again or
leave the unit idle for new setting to
effect. Press the PTY/CLK button
anytime to view the time clock display.
11. Preset Beep Sound Off
Press the SEL button repeatedly un-
til “BEEP ON” is displayed. Turn the
VOL +/- Button to select "BEEP OFF"
or "BEEP ON", then leave the unit idle
for setting to take effect.
12. Preset Equalizer Function
Press the SEL Button repeatedly un-
til “EQ” indication is displayed then
rotate the Volume knob to choose
between the EQ sound effects. The
Sequence of equalizer setting will be
as follows:
FLAT
OFF
POP ROCK
CLASSIC
Summary of Contents for GCD200
Page 1: ...CD receiver gCD200...
