28
MAINTENANCE INSTRUCTIONS
Brake fluid level inspection
- Check the brake fluid level using the inspection windows on both
the front
A
and rear
B
brake tanks. The level should at least reach
halfway up the inspection window.
If brake fluid is required:
- Ensure that brake fluid is not leaking from: front and rear brake
cylinder seals, hoses and joints. If there is any leak, visit a GAS
GAS workshop immediately.
- Add brake fluid, complying to the DOT 3 or DOT 4 standards, to
the corresponding brake fluid tank in order to re-establish the correct
level.
Checking brake pad wear
- Check the thickness of both the front and rear brake pads.
- Minimum brake pad thickness
A
: 1 mm
- If any brake pad is less than 1mm thick then replace the complete
set.
HANDLEBARS
Adjustment
In order to better suit the driver size and preferences, the handlebar
position may be adjusted forwards or backwards.
Loosen the handlebar
A
clamp bolts
B
then place the handlebars
in the required position.
1 mm
A
B
Tighten the bolts to 25 Nm, firstly the forward bolts then the rear
bolts. If the handlebars are correctly installed, there will be a minimal
gap at the front and rear of the clamp after tightening
A
.
A
