TUNING THE CHASSIS 10
41
H01189-10
Main work
–
Remove screws
1
. Remove the handlebar clamp. Remove the han-
dlebar and lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
2
. Take off handlebar supports
3
.
–
Position rubber bushings
4
and push through nuts
5
from
below.
–
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
2
.
Guideline
Screw, handlebar
support
M10
40 Nm (29.5 lbf ft)
Loctite
®
243™
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamp.
–
Mount screws
1
but do not tighten yet.
–
First bolt the handlebar clamp with screws
1
onto the longer,
higher side of the handlebar supports so that both parts touch.
Guideline
Screw, handlebar
clamp
M8
20 Nm (14.8 lbf ft)
–
Tighten screws
1
evenly.
Guideline
Screw, handlebar
clamp
M8
20 Nm (14.8 lbf ft)
Finishing work
–
Mount the handlebar cushion.
