Oil change
NOTE
The engine must be completely cool and then warm up the
engine again for a few minutes to normal operating temperature,
to register the correct engine oil temperature and to obtain an
accurate oil level measurement.
- The transmission oil should be changed periodically to ensure
long engine life.
- Warm up the engine for 5 minutes so any oil sediment will float.
- Stop the engine, and place an oil pan under the engine.
- Remove the drain screw (see previous photo) and place the
motorcycle in riding position to allow the oil to drain out.
- Clean the drain screw magnet of any iron particles.
- Tighten the oil drain screw with its O-ring to 20-Nm.
- Remove the oil filler opening plug
(C)
and pour 900 cc of new
transmission 750 cc for model 125cc.
- Check the oil level, after kicking the kick-start pedal 3 or 4 times.
- Install the oil filler opening plug.
-
21
-
Oil level inspection
- Wait a few minutes if the motorcycle has been operating.
- If the level is low, add the necessary quantity of oil by opening the
plug
(C)
. Use the same type and oil manufacturer used currently
with the engine.
Transmission Oil
Viscosity: SAE 10W30
Capacity: 750 cc (EC 125)
- Check the oil level
through the
inspection window
in the lower right
hand side of the
engine (A).
- Oil level must be
kept between the
maximum and
minimum marks.
- If the lever is too
high, you have to
remove the excess
oil through the drain
plug (B).
(B)
(A)
(C)