GAS GAS 3215013en, Owner'S Manual

Page: 106 / 150

15 ELECTRICAL SYSTEM
104
15.11 Changing the turn signal bulb
Note
Damage to reflector Grease on the reflector reduces the light intensity.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
–
Clean and degrease the bulbs before mounting.
–
Do not touch the bulbs with your bare hands.
E00360-10
Main work
–
Remove the screw on the rear of the turn signal housing.
–
Carefully remove turn signal glass
1
.
–
Lightly squeeze orange cap
2
in the area of the holding lugs and
take it off.
–
Press the turn signal bulb lightly into the socket, turn it counter-
clockwise by about 30°, and pull it out of the socket.
Info
Do not touch the reflector with your fingers and keep it free
from grease.
–
Press the new turn signal bulb carefully into the socket and turn it
clockwise until it stops.
Turn signal (R10W / socket BA15s) ( p. 132)
–
Mount the orange cap.
–
Position the turn signal glass.
–
Insert the screw and first turn counterclockwise until it engages in
the thread with a small jerk. Tighten the screw lightly.
Finishing work
–
Check that the turn signal system is functioning properly.
15.12 Changing the combination instrument battery
Preparatory work
–
Remove the headlight mask with the headlight. ( p. 101)
F03251-10
Main work
–
Remove screws
1
along with the washers.
–
Pull the combination instrument upward out of the holder.