PT LINK
POWER INPUT A
GND
REM
+12V
GND
POWER INPUT B
+12V
GND
GND
GND
REM
POWER
INPUT-B
PT LINK
+12V
+12V
+12V
POWER
INPUT-A
POWER
INPUT-C
GND
GND
GND
REM
POWER
INPUT-B
PT LINK
+12V
+12V
+12V
POWER
INPUT-A
POWER
INPUT-C
+12V(B+), GND, REM
(COMPETITION 7000.1D)
(COMPETITION 12000.1D)
5
Installation of the amplifier should be done in the following steps:
1. Ensure that the ground is appropriate, then connect it to the amplifier.
2. Next step is to connect the +12V wire. Ensure all power terminals are used.
This cable has to be fused at the battery for safety precautions.
3. The final step is connecting the switched remote.
CAUTION
Before attempting to make any connections to power supply, input and output connectors,
make sure the amplifier is in OFF state. Check polarity of cables carefully as using reversed
polarity will cause damage to amplifier. And to prevent power loss and overheating of wiring,
always use the recommended wire gauges.
CAUTION
GND (GROUND CONNECTION)
For connection to chassis ground. For optimum performance, 0 gauge cable is recommended.
REM (REMOTE)
Connect to sw12V from the head unit.
+12V / B+ (POWER CONNECTION)
For connection to positive terminal of battery (+12).
For optimum performance, 0 gauge cable is recommended.
PT Link
If you link two same amplifiers as master and slave connection, then connect the 2 amplifies using
the PT Link cable provided. In case when the master unit enters into protection, the slave unit will also
enter into protection thereby protecting the slave unit from unexpected damage.
