Garwoods EC-2923, Installation & Operating Instructions Manual

Page: 4 / 28

3
2
、
Installation Guideline
★
Installation should be followed below requirements
：
The walls on top of the working face and next to the installation of the electric hob must
be heat-proof.
The laminated boards and adhesive used for installation must be heat-resistant.
For any installation method, the air under the electric hob and behind the cooking range
should have enough space for cooling in order to ensure the safety of operating the
electric hob.
Based on the prescribed dimensions, a square hole is opened on the work table. Ensure
the distance between any side of the work table and the walls is
100mm.
Protect the opening: If in contact with damp, the laminated boards used in marking the
work table will easily expand more. It is required to stick varnish or special adhesive onto
the edge of the opening in order to prevent any steam from condensation under the work
table.
For any condition of installation, the electric hob should have a good ventilation condition
with air inlet and air outlet not blocked.
Don’t place other equipments on the working face of the double cooking zones of the
electric hob and within the range of 30cm around the working face.
If choosing a table-top installation, ventilation hole shall be at least 100mm from wall
surface.
The electric hob must be complied with a 13A power outlet.
★
Steps on Installation
：
~ Open an installation hole on the worktop of cabinet as per illustration 1 .
(Note : The height shall be more than 100mm)
Cut out dimensions(unit/mm)
(W) 670 x (D) 350 x (H) 100
illustration 1
* If the installation hole on the work table is a new open, it is recommended a depth
to 370mm and put the electric cooker into the hole at front side so at to have a good
ventilation condition.