OPERATING INSTRUCTIONS
7
Operating Instructions
- Press the "MODE" button until the "COOL"
indicator light comes on.
- Press the ADJUST buttons "
" or " " to
select your desired room temperature. The
temperature can be set within a range of
- Press the "FAN" button to choose the fan speed.
▲
O
O
O
O
▲
- Press the "MODE" button until the
"DRY" indicator light comes on.
COOL operation
fan speed. The temperature cannot be
adjusted.
FAN operation
TIMER operation
ding on what temperature you have
selected and the room temperature.
- When the unit is on, first press the
indicator light illuminates. It indi-
cates the Auto Stop program is
initiated.Press the Timer button
- Press or hold the UP or DOWN
button to change the Auto time by
0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24
hours. The control will count down
the time remaining until start.
-
The selected time will register in 5
seconds and the system will autom-
atically revert back to display the
previous temperature setting.
- Turning the unit ON or OFF at any
time or adjusting the timer setting
to 0.0 will cancel the Auto Start/
Stop timed program.
- When the malfunction (E1 or E2)
occurs, the Auto Start/Stop timed
program will also be cancelled.
indicator light
When the unit is off, first press the
ator light illuminates. It indicates
When the unit.Press the Timer button
Stop program is initiated.
-
The air conditioner will control the room
temperature point set by you.
- Under AUTO mode, you can not
select the fan speed.
- Under this mode, you cannot select a
fan speed or adjust the temperature.
- Keep windows and doors closed for
the best dehumidifying effect.
E2-
E4-
Protection codes:
P1-
Unplug the unit and plug it back in.
If error repeats, call for service.
Unplug the unit
and plug it back in. If error repeats,
call for service.
Bottom tray is full - Connect the
drain hose and drain the collected
water away. If error repeats, call
for service.
Error codes:
E1-
Unplug the unit and plug it back in.
If error repeats, call for service.
- When you set the air conditioner in
AUTO mode, it will automatically select
the priority of the code display order is:
E4--E2--E1--P1.
Room temperature sensor error -
Evaporator temperature sensor error -
Remove italics error -
NOTE:
When more than one code occur,
17 C-30 C/62 F-88 F.
DRY operation
- Do not install the duct in the window.
AUTO operation
cooling, heating (except in cooling-only models
), or fan only operation depen-
temperature automatically around the
- Press the "MODE" button until the
"FAN" indicator light comes on.
- Press the "FAN" button to choose the
- Do nto install the duct in the window.
TIMER button, The TIMER OFF
again, the TIMER ON
illuminates. It indicates the Auto
Start program has been initiated.
TIMER button, The TIMER ON indic-
the Auto Start program has been initiated.
again, the TIMER OFF indicator light
illuminates. It indicates the Auto