6
Setting a 12 or 24 hour time display
To select the time display in 12-hour or 24-hour format, press the
DOWN
button in basic view mode.
If the
12-hour format is selected, the PM indicator will be displayed next to the time from 12:00 p.m. until 11:59
p.m.
Temperature units
To select the display of the measured temperature i
n degrees Celsius °C or Fahrenheit °F, press the
UP
button in basic view mode.
Switching between wireless sensor channels
If multiple wireless sensors are paired with the main unit, press the
CHANNEL
button to display the
measured temperature and relative humidity values of individual wireless sensors.
If a double circular arrow is displayed, the measured values of all connected wireless sensors will gradually
be displayed on the main unit display.
Display backlight
The main unit allows you to adjust the display backlight intensity. To adjust it, press the
SNOOZE/LIGHT
button in the basic display mode.
The display backlight has two levels of brightness and a turn-off option.
Only short-time backlighting for 8 s and two levels of brightness can be used with battery power. The main
unit is equipped with a sound sensor, and when powered by batteries only, the display can be illuminated
by sound, for example, tapping, clapping, etc.
Setting the alarm time
The weather station has the option to set two alarm times. In the basic display, select alarm time 1 by
pressing the
MODE
button
(AL 1, default setting at 6:00 a.m.) or alarm time 2 (AL 2, default setting 0:00
a.m.). Then press the
MODE
button again
and hold for 3 seconds. The hour digits begin to flash.
Use the
UP
or
DOWN
buttons to set the desired alarm hour and confirm by pressing
MODE
.
The minute digits begin to flash. Use the
UP
or
DOWN
buttons to set the desired alarm minute.
Confirm the settings by pressing
MODE
.
If no button is pressed for 8 s during setup, the display will change to the basic display.
Snooze function
When the alarm signal is activated at the set time, press the
SNOOZE/LIGHT
button to interrupt and
postpone the alarm to a later time. The snooze time can be set from 3 to 20 minutes. Default setting
is 5 minutes.
To set the snooze time, press
SNOOZE/LIGHT
and hold for 3 s. The Zz symbol will appear in place of the
time display, and the digit 05 (the default 5-minute snooze setting) will flash.
use the
UP
or
DOWN
buttons to set the desired snooze minute within the range of 3.
to 20 minutes and confirm by pressing
MODE
.
If no button is pressed for 8 s during setup, the display will change to the basic display.
Turn on the alarm clock
In the basic display mode, press
ALARM
. Press one time to turn on alarm clock1, twice
to turn on alarm clock 2, three times to turn on alarm clocks 1 and 2, and switch off the alarm clock by
pressing the fourth time. Icons for respective alarms AL1 and AL2 are always shown on the display
Turning off the alarm signal
When the alarm signal is activated at the set time, you can activate the snooze function by pressing
SNOOZE/LIGHT
. The Zz symbol will flash on the display. The alarm signal will be re-activated after the set
time.
