GARNET GAE -3030
7
2.3 HardWare Installation
☞
To install modem into PC, follow below steps.
1. Turn off your computer and all attached peripheral devices (printer, monitor,
etc.) and unplug them from the electrical outlet.
?
CAUTION : To avoid risk of electric shock, make sure your computer and all
peripheral devices are turned off and unplugged.
2. Attach power supply to power inlet connector
3. Plug power supply cable into standard electrical socket.
4. Connect the RJ11 port to the modem( ) using the phone line
5. For Ethernet Modem installation, connect one end of the Ethernet cross-over
cable to the modem and the other end to the PC. If an Ethernet hub is being used,
a straight–through cable will be needed to attach the modem to the hub.
2.4 SoftWare Installation
☞
The modem has its software image stored in flash. The Ethernet bridge/router
image is stored in flash by default.
In order to use the modem, the modem will need to be configured as a bridge or
router. There is no installation of software on the PC for this, except for the
normal Ethernet LAN adapter installation.
The modem configuration can be viewed and modified through the console
which is accessible through the RS-232 serial connection. To use the serial
interface, a straight-through cable is needed between the modem and a terminal
(could be a PC running a terminal emulation package).
The PHY can be configured to attempt the layer 1 connection in one of the
following modes:
?
T1.413
