GARNET GAE -3030
13
If the ATMOS image(s) have been corrupted and the Client Access Device has
booted in Recovery Mode, it may be necessary to update both the image and
NPimage files. If this is necessary follow the steps in section
2.2.1, copy the NPimage file from the Client Access Device CD to the same
directory as the other TFTP files, and run the following command:
tftp> put NPimage
Either instead of the command:
tftp> put image
or just after it. In other words, it is possible to update the NPimage separately
or during the same update as the
image
file.
2.12 PHY Flash Update
2.12.1 Updating the PHY flash code
?
Power-up the Client Access Device with the Ethernet cable connecting the
board to the house network.
?
If the console prompt does not show the board IP address see section 5.1 to
set the IP address.
?
On the PC where TFTP is to be run, create a file called
tftplock.key
which
contains the text
“password”
.
Also create the files tftpupdt.beg and
tftpupdt.end
which contain the text “junk”
?
Copy the file
tftpupdt.nof
to the same directory the above files are located in.
?
From this directory run TFTP.
?
In TFTP, run the following commands:
tftp> connect 172.16.1.239 (substitute the IP address of the test board)
tftp> bin
tftp> put tftplock.key
tftp> put tftpupdt.beg
tftp> put tftpupdt.nof
tftp> put tftpupdt.end
?
From the Client Access Device console run the following commands:
172.16.1.239> bun adi super
172.16.1.239> bun adi update
