One of two methods may be chosen to receive waypoints and routes from
a PC or from another GPS 100. “RECEIVE (UPDATE)” allows the unit to
receive new waypoints and routes without deleting old waypoints and routes
not changed by the receive operation. “RECEIVE (REPLACE)” deletes all
of the unit’s old waypoints and routes, including waypoints used in proximity
alarms, and replaces them with new waypoints.
To transfer waypoints and routes from a PC to a GPS 100...
·
Select “RECEIVE (UPDATE)” or “RECEIVE (REPLACE)” on the
Data Transfer Page.
·
Move the cursor over “OK?” and press the ENT key.
·
Run the PC upload program.
·
The GPS 100 will display the message “WPT/RTE RX STARTED”
when the first data record is received. The number of waypoints and
routes received will be displayed on line 2.
·
The PC will indicate when the transfer operation is complete.
·
Select “STOP” and press the ENT key with the cursor over “OK?” to
stop the transfer and continue normal operation.
To transfer waypoints and routes from one GPS 100 to another...
·
Select “RECEIVE (UPDATE)” or “RECEIVE (REPLACE)” on the
Data Transfer Page of the unit to receive the waypoints and routes.
·
Move the cursor over “OK?” and press the ENT key.
·
Select “TRANSMIT” on the unit that will transmit waypoints and
routes.
·
Move the cursor over “OK?” and press the ENT key.
·
The receiving GPS 100 will display the message “WPT/RTE RX
STARTED” when the first data record is received. The number of
received waypoints and routes will be displayed on line 2 (the
transmitting GPS 100 will also display the number of waypoints and
routes transmitted).·
The transmitting GPS 100 will display the message “WPT/RTE TX
COMPLETE” when all data has been transmitted.
·
Select “STOP” and press the ENT key with the cursor over “OK?” to
stop the transfer and continue normal operation.
NOTE: While a GPS 100 is receiving or transmitting waypoint and route
data, only the Message Page may be viewed (i.e., any keypress to access
another page will result in the error tone).
11-13
