background image

Transom Mount Intelliducer Installation Instructions

Software License Agreement

BY USING THE INTELLIDUCER, YOU AGREE TO BE BOUND BY THE TERMS AND CONDITIONS OF 

THE FOLLOWING SOFTWARE LICENSE AGREEMENT. PLEASE READ THIS AGREEMENT CAREFULLY.
Garmin grants you a limited license to use the software embedded in this device (the “Software”) in binary 

executable form in the normal operation of the product. Title, ownership rights, and intellectual property rights in and 

to the Software remain in Garmin.
You acknowledge that the Software is the property of Garmin and is protected under the United States of America 

copyright laws and international copyright treaties. You further acknowledge that the structure, organization, and 

code of the Software are valuable trade secrets of Garmin and that the Software in source code form remains 

a valuable trade secret of Garmin. You agree not to decompile, disassemble, modify, reverse assemble, reverse 

engineer, or reduce to human readable form the Software or any part thereof or create any derivative works based on 

the Software. You agree not to export or re-export the Software to any country in violation of the export control laws 

of the United States of America.

Declaration of Conformity (DoC)

Hereby, Garmin, declares that this Intelliducer is in compliance with the essential requirements 

and other relevant provisions of Directive 1999/5/EC.
To view the full Declaration of Conformity, see the Garmin Web site for your 

Garmin product: 

www.garmin.com/products/intelliducer/

. Click 

Manuals

, and 

then select the 

Declaration of Conformity

 link.

Summary of Contents for Intelliducer Transom Mount Sensor with Depth & Temperature (NMEA 0183









Reviews: