190-00734-17
GTX 335 w/GPS Installation Guidance
Rev. 1
Page 4-19
4.4.2 Configuration Module Installation
1. Crimp pin contacts (3) onto each wire of the four-conductor wire harness (2). Strip 0.17" of
insulation from each wire prior to crimping.
2. Insert newly crimped pin contacts and wires (2, 3) into the correct locations in the connector
housing as shown in figure 4-11.
3. Plug the four-conductor wire harness (2) into the connector on the PCB board (1).
4. Insert PCB board (1) into the backshell recess.
5. Orient the connector housing so that the inserted four-conductor wire harness (2) is on the same
side of the backshell, as the inserted PCB board (1), as shown in figure 4-11.
Table 4-7 Configuration Module Kit, P/N 011-00979-03
Figure 4-11 Configuration Module Assembly
Item
Description
P/N
QTY
1
Configuration module, PCB board assembly w/EEPROM
011-02178-00
1
2
4-conductor harness
325-00122-00
1
3
Pin contact, crimp, #22D
336-00021-00
4
