Page 3-6
GTS 8XX/GPA 65 Installation Manual
Revision 4TP
190-00587-00
3.5.1 Post Installation Configuration & Checkout
Before beginning the installation calibration, the installer must perform a visual inspection to verify the
coaxial cables are installed correctly based upon the system and antenna configuration.
NOTE
Tests performed with a ramp tester should be performed away from buildings that may
reflect the signal. Local air traffic control should be advised if the ramp tester has an
altitude programmed into it that may cause interaction with other TCAS-equipped traffic.
The following actions need to be performed after the equipment is installed:
1.
GTS 8XX Configuration Options
2.
CDTI (Cockpit Display of Traffic Information) Display setup and configuration
3.
Calibration
4.
Self test
5.
Ramp test and return to service tests
6.
Antenna verification
3.5.2 GTS 8XX Configuration Options
GTS 8XX Configuration is performed using a computer (installed with Microsoft Windows XP or later)
and the GTS 8XX Install Tool, Garmin part number 006-A0242-00. The tool is available for download
from the Dealers Only portion of the Garmin website (www.garmin.com).
G1000 Installations:
When installed as part of the G1000 integrated flight deck, the GTS 8XX must have FAA approved
configuration data. Configuration data is loaded to the GTS 8XX from an aircraft-specific G1000
software loader card.
For basic configuration information refer to the G1000 Line Maintenance and Configuration Manual
(190-00303-04), G1000 System Maintenance Manual LJ/VLJ (190-00903-00), or the G1000 System
Maintenance Manual Standard Piston/Turboprop Aircraft (190-00907-00). For actual
installation/checkout, use only aircraft manufacturer approved or STC checkout procedures.
Non-G1000 Installations:
Configuration and software uploading is accomplished by using a computer (installed with Microsoft
Windows XP or later) and the GTS 8XX Install Tool. An optional USB pigtail installed in the wiring
harness may be used.
The GTS 8XX Install Tool allows for configuration, diagnostics, and upload of GTS 8XX software.
The following GTS 8XX modes are accessible with the GTS 8XX Install Tool.
•
Normal Mode – Allows selection of Traffic Mode to Standby, Operate, or Test. Reports
System Faults, Status Flags, and Operating Status. Allows Ground Test Mode to be
Enabled or Disabled.
•
Configuration Mode – Allows selection of installation options
•
Upload Mode – Allows upload of software to GTS 8XX unit
•
Debug Mode – Runs system diagnostics
