GST 10 Installation and Configuration Instructions
Assigning a NMEA 2000 Temperature Source
To use the GST 10 adapter, you must select the source for the temperature data.
1. From the NMEA 2000 Devices list, select the GST 10 device.
2. Select an option:
For most Garmin chartplotters, select
Review
>
N2K Temp. Source
.
For other Garmin marine devices, select
Config
>
N2K Temp. Source
.
3. Select the location of the temperature sensor.
Configuring the Temperature Offset
If the temperature data displayed on the gauge connected to the GST 10 adapter is not the same
as temperature data displayed on other devices, you can configure the temperature offset to
increase or decrease the displayed temperature by a specific amount.
1. From the NMEA 2000 Devices list, select the GST 10 device.
2. Select an option:
For most Garmin chartplotters, select
Review
>
Temperature Offset
.
For other Garmin marine devices, select
Config
>
Temperature Offset
.
3. Select the temperature offset as a positive or negative decimal number, in degrees.
4. Select
Done
.
Troubleshooting the Sensor Number
If multiple GST 10 adapters are assigned to the same NMEA 2000 temperature source,
each adapter is assigned a unique sensor number automatically. If the “Invalid NMEA 2000
temperature configuration” error message appears, you must assign a unique sensor number to
each adapter.
For example, if two adapters are assigned the NMEA 2000 temperature source value of Live
Well and the error message appears, you must assign each adapter a unique number.
1. From the NMEA 2000 Devices list, select the GST 10 device.
2. Select an option:
For most Garmin chartplotters, select
Review
>
Sensor Number
.
For other Garmin marine devices, select
Config
>
Sensor Number
.
3. Select a sensor number.
4. Select
OK
.
•
•
•
•
•
•