GST 10 Installation and Configuration Instructions
4. Connect the NMEA 2000 connector on the GST 10 adapter to the T-connector added in
step 3.
5. (Optional) If the GST 10 adapter cannot connect directly to the NMEA 2000 backbone, route
a NMEA 2000 drop cable (not included) to the bottom of the T-connector added in step 3.
Use a drop cable with a length up to 20 ft. (6 m). Connect the drop cable to the T-connector
and to the NMEA 2000 connector on the adapter.
notiCe:
If you have an existing NMEA 2000 network on your boat, it should already be
connected to power. Do not connect an additional NMEA 2000 power cable to an existing NMEA
2000 network, because only one power source should be connected to a NMEA 2000 network.
➊
➋
➋
➌
➍
➎
Connecting the GST 10 Adapter to an
Existing NMEA 2000 Network
➊
GST 10 adapter
➋
NMEA 000 device (not included)
➌
Drop cable (optional - not included)
➍
T-connector (one included)
➎
Existing NMEA 000 network
Configuring the GST 10 Adapter
note:
This section provides specific configuration information for the GST 10 adapter using
your compatible Garmin display device. To access the NMEA 2000 configuration menu on your
display device, consult the documentation provided with your display device.
Calibrating the Water Speed
To use the GST 10 adapter, you must calibrate the water speed.
1. From the NMEA 2000 Devices list, select the GST 10 device.
2. Select an option:
For most Garmin chartplotters, select
Review
>
Calibrate Water Speed
.
For other Garmin marine devices, select
Config
>
Calibrate
Water Speed
.
3. Follow the on-screen instructions to calibrate the water speed.
•
•