8
GMR 404/406 Marine Radar Installation Instructions
Radar Setup
To take full advantage of the GMR 404/406 features, the Garmin Marine Network may require a software update. A software update card is
provided in the Marine Data Management Kit.
The newly installed GMR 404 or 406 will not transmit until the radar is properly configured. Follow the instructions below to properly
configure the radar.
Turn on the Garmin Marine Network:
1. Press the
Power
key on the MFD. The scanner turns on with the network. The Welcome Page appears showing that a GMR 404/406 is
detected as a network connection.
2. When
I Agree
turns yellow, press the
ENTER
key.
Configuring the Radar:
1. From the Map Page, press
QUIT
to clear the banner message “Radar Needs Configured” and show the Radar Setup Page.
2. Using the
Rocker
, highlight the
Advanced
tab, then the
Antenna Size
field, and press
ENTER
.
3. Select the correct antenna size,
4 foot
or
6 foot
, and press
ENTER
.
4. When prompted, press and hold
FCTN
to begin radar transmission. Before beginning radar transmission, verify that the area around the
scanner is clear. Microwave energy can be harmful to humans and animals. While the radar is transmitting, avoid looking directly at the
scanner. The eyes are the most sensitive part of the body to microwave radiation.
Front of Boat Offset
Depending on the scanner installation, it may be necessary to adjust the Front of Boat Offset. If the scanner installation requires a 180° offset,
change the Front of Boat Offset to 180° and test the radar. If the Front of Boat Offset needs further adjustment, continue with the procedure
below.
Using a magnetic compass, take an optical bearing of a stationary target located within viewable range. Measure the target bearing on the radar.
If the bearing deviation is more than +/- 1°, then do the following to correct the Front of Boat Offset.
To change the Front of Boat Offset:
1. From the Radar Page, press the
ADJ
key to display the Adjustment Menu.
2. From the Adjustment Menu, select
Setup,
and press
ENTER
. Using the
Rocker
, select the
Advanced
tab.
3. Using the
Rocker
, highlight the
Front of Boat Offset
slider, and press
ENTER
.
4. Press left on the
Rocker
to adjust to a negative value, or press right to adjust to a positive value. The preview window changes as you
adjust the slider.
5. Once an offset has been determined, press
ENTER
to save, then press
QUIT
to return to the Radar Page. Your new Garmin Marine
Radar is now ready to use! Refer to the
GPSMAP 3206/3210 Owner’s Manual
for details about operating the radar.
Select Antenna Size
Summary of Contents for GMR 404
Page 1: ...GMR 404 406 marine radar installation instructions...
Page 16: ......
