Garmin GDL 88, Installation Manual

Page: 25 / 44

GDL 88 TSO Installation Manual Page 4-3
190-01122-00 Rev. A
4.2.2 UAT Antenna Options
4.3 Miscellaneous Options
Item Garmin P/N Mfg P/N
Connector, BNC, Male, Clamp 330-00087-00 N/A
GPS 1.57542 GHz Notch Filter 330-00067-00 N/A
Connector, TNC, Male, Clamp N/A 031-4452 [1]
[1] This part is not available from Garmin.
Vendor Contact Information (provided for convenience only):
Amphenol RF, Four Old Newtown Road, Danbury, CT 06810 Phone: 800-627-7100
4.4 Installation Materials not Supplied
4.4.1 Installation Materials Required but not Supplied
The GDL 88 is intended for use with the standard aviation accessories. The following items are required
for installation, but not supplied.
Wire (MIL-W-22759/16 or equivalent)
Shielded Wire (MIL-C-27500 or equivalent)
Mounting Screws (8 minimum – MS24693 Screw, Machine, Flat Countersunk Head 100°, Cross-
recessed with .1380-32 UNC-2A Thread, Corrosion Resistant Steel)
Push/Pull (manually resettable) Circuit Breakers
Tie Wraps or Lacing Cord
Ring Terminals (for grounding)
Coaxial Cable (RG-400, RG-142B or equivalent – Refer to Section 4.11 for additional
information).
4.5 Special Tools Required
Some of the connectors use crimp contacts. The table below identifies crimp tools required to ensure
consistent, reliable crimp contact connections for the rear D-sub connectors.
Table 4-3. Recommended Crimp Tools (or Equivalent)
Manufacturer
Hand Crimping
Tool
22
– 28 AWG (P1001 – P1005)
Positioner
Insertion/
Extraction Tool
Military P/N M22520/2-01 M22520/2-09
M81969/14-01
M81969/1-04
Positronic 9507-0-0-0 9502-4-0-0 M81969/1-04
ITT Cannon 995-0001-584 995-0001-739
000849490
274-7048-000MIL
AMP 601966-1 601966-6
91067-1
2031838-1
Daniels AFM8 K42
M81969/14-01
M81969/1-04
Astro 615717 615725
M81969/14-01
M81969/1-04
NOTE
Insertion/extraction tools from ITT Cannon are all plastic; others are plastic with metal tip.