Garmin EDGE 530, Owner'S Manual

Page: 6 / 30

About the Battery
WARNING
This device contains a lithium-ion battery. See the Important
Safety and Product Information guide in the product box for
product warnings and other important information.
Installing the Standard Mount
For the best GPS reception, position the bike mount so the front
of the device is oriented toward the sky. You can install the bike
mount on the stem or the handlebars.
1
Select a secure location to mount the device where it does
not interfere with the safe operation of your bike.
2
Place the rubber disk on the back of the bike mount.
The rubber tabs align with the back of the bike mount so it
stays in place.
3
Place the bike mount on the bike stem.
4
Attach the bike mount securely using the two bands .
5
Align the tabs on the back of the device with the bike mount
notches .
6 Press down slightly and turn the device clockwise until it
locks into place.
Installing the Out-Front Mount
NOTE: If you do not have this mount, you can skip this task.
1
Select a secure location to mount the Edge device where it
does not interfere with the safe operation of your bike.
2
Use the hex key to remove the screw from the handlebar
connector .
3 Place the rubber pad around the handlebar:
• If the handlebar diameter is 25.4 mm, use the thicker pad.
• If the handlebar diameter is 31.8 mm, use the thinner pad.
4
Place the handlebar connector around the rubber pad.
5
Replace and tighten the screw.
NOTE: Garmin ® recommends tightening the screw so the
mount is secure, with a maximum torque specification of
7 lbf-in. (0.8 N-m). You should check the tightness of the
screw periodically.
6
Align the tabs on the back of the Edge device with the bike
mount notches .
7
Press down slightly and turn the Edge device clockwise until
it locks into place.
Releasing the Edge
1
Turn the Edge clockwise to unlock the device.
2
Lift the Edge off the mount.
Installing the Mountain Bike Mount
NOTE: If you do not have this mount, you can skip this task.
1
Select a secure location to mount the Edge device where it
does not interfere with the safe operation of your bike.
2 Use the 3 mm hex key to remove the screw from the
handlebar connector .
3
Select an option:
• If the handlebar diameter is 25.4 mm, place the thicker
pad around the handlebar.
• If the handlebar diameter is 31.8 mm, place the thinner
pad around the handlebar.
• If the handlebar diameter is 35 mm, do not use a rubber
pad.
4
Place the handlebar connector around the handlebar, so that
the mount arm is above the bike stem.
5
Use the 3 mm hex key to loosen the screw on the mount
arm, position the mount arm, and tighten the screw.
NOTE: Garmin recommends tightening the screw so the
mount arm is secure, with a maximum torque specification of
20 lbf-in. (2.26 N-m). You should check the tightness of the
screw periodically.
2 Introduction