Installing the Transceiver on a High Pressure Hose Extension
WARNING
Always use the pre-installed flow restrictor when using the transceiver directly attached to your regulator
(
Installing the Transceiver on Your Tank Regulator, page 4
). Always use the included air spool when connecting
the transceiver to a high pressure hose extension. Using the transceiver without either the flow restrictor or air
spool could result in serious injury or death from an air pressurization failure.
Before you install the transceiver on a high pressure hose extension certified to the EN 250:2014 standard, you
should read the transceiver position tips and choose a position that provides the best line of sight to the watch
(
Transceiver Position Tips, page 1
).
To install the transceiver, you need an open-ended wrench and a small flat screwdriver or flat-nose pliers.
1 Use a screwdriver or pliers to carefully remove the flow restrictor from the transceiver.
NOTICE
Use care when removing the flow restrictor to avoid damaging the device.
2 Insert the large end of the air spool into the transceiver.
Installation and Setup
5
Summary of Contents for DESCENT 12
