Dakota Series Owner’s Manual
Appendix
Attaching a Carabiner
1. Position the carabiner clip in the
slots on the mounting spine of the
Dakota.
Carabiner
Carabiner
clip
Mounting
spine
2. Slide the clip up until it locks in
place.
To remove the carabiner clip, lift
the bottom of the clip and slide the
carabiner clip off the mounting spine.
Calibrating the
Touchscreen
The Dakota screen does not normally
require calibration. However, if the
buttons do not seem to be responding
properly, use the following process.
To calibrate the touchscreen:
1. While the unit is turned off, press
and hold the
Power
key for
approximately 30 seconds.
2. Follow the instructions on the
screen until “Calibration is
complete” is displayed.
190-01069-00_0A.indd 37
4/17/2009 1:19:12 PM