Garmin Colorado Series, Quick Start Manual

Page: 3 / 64

Additional Functions
To install batteries:
1. Remove the battery cover
by lifting the latch and
sliding the cover off the
Colorado.
2. Insert the batteries,
observing the diagram
molded into the battery
compartment.
3. Replace the battery cover
by sliding it back onto the
Colorado and fastening the
latch.
To attach the carabiner clip:
1. Position the carabiner clip in the slots on the mounting
spine of the Colorado.
2. Slide the clip up until it locks in place.
3. To remove the carabiner clip, lift the bottom of the clip and
gently push down on the carabiner clip until it releases.
Basic Operation
First-time startup:
1. Press and hold the Power key until the Garmin logo
appears on the screen.
2. Starting the Colorado the rst time requires you to choose
your language, time zone, and Daylight Saving mode.
When the Language page appears, highlight the preferred
language and press
ENTER .
3. Highlight the preferred time zone and press ENTER .
4. Highlight the preferred Daylight Saving mode and press
ENTER . The Colorado then shows the Map page.
5. Take your Colorado to an area with a clear view of the sky.
6. If the cursor on the Map page is blinking, wait for the
Colorado to collect satellite data and establish its current
location.
7. To turn off the Colorado, press and hold the Power
key.
NOTE:
You must be outdoors with a clear view of the sky to
acquire satellites.
Battery compartment
Battery cover
Latch
Language
Time Zone Daylight Saving
er clip unti t l it releases.
Carabiner Mounted
on Colorado
Carabiner clip