Garmin Beechcraft 200 Series, Cockpit Reference Manual

Page: 45 / 270

Garmin G1000 NXi Cockpit Reference Guide for the Beechcraft 200/B200 Series 190-02040-01 Rev. B 21
Nav/Com/XPDR/Audio Panel
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Annun/Alerts
Appendix
Index
Flight
Instruments
EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazar
d
Avoidance
AFCS
Additional
Featur
es
Abnormal
Oper
ation
Annun/Alerts
Appendix
Index
Intercom Volume and Squelch
The VOL/CRSR Knob controls selection and volume or manual squelch adjustment
for audio sources that may not be adjustable anywhere else in the system. The small knob
controls the volume or squelch. Turning the large knob activates and/or moves the cursor
(flashing white annunciator or flashing blue annunciator in Blue-Select Mode) to select
the audio source to adjust. The cursor will time-out after a few seconds and the position
of the cursor will always default back to the
CREW Key. Pressing the small knob cancels
the cursor.
PASSENGER ADDRESS (PA) SYSTEM
A passenger address system is provided by pressing the
PA
Key to deliver messages to
the passengers. The message is heard by the other pilot on the headset only if the CREW
ICS Key is enabled. PA messages are one way from the flight deck to the passengers.
A Push-to-talk (PTT) must be pressed to deliver PA announcements to the passengers
over their headphones.
When PA is selected on the Audio Panel, the annunciator flashes about once per second
while pressing the PTT, the COM MIC annunciators are no longer lit, and the active COM
frequency for that Audio Panel changes to white, indicating that there is no COM selected.
CLEARANCE RECORDER AND PLAYER
The PLAY Key controls the play function. The PLAY annunciator remains lit to indicate
when play is in progress. The PLAY annunciator turns off after playback is finished.
Pressing the PLAY Key once plays the latest recorded memory block and then returns
to normal operation. Pressing the PLAY Key again during play of a memory block plays
the previously recorded memory block. If a COM input signal is detected during play of
a recorded memory block, play is halted.
Press the microphone push-to-talk button to stop playback.
Powering off the unit automatically clears all recorded blocks.
BLUE-SELECT MODE (GMA 1360)
The Blue-Select Mode is entered by pressing the small knob when the volume control
cursor (flashing white annunciator) is not active. If the volume control cursor is active,
press the small knob twice. The first press will cancel the volume control cursor, the
second will activate Blue-Select Mode.
The annunciator over the TEL Button will be flashing blue. Any combination of the
annunciators over the
CREW ICS
Button and the
PASS ICS
Button may be blue. Select
the desired button to turn the blue annunciator on or off to distribute the telephone audio
to selected crew/passenger positions. Turn the large knob to select MUS1 or MUS2, and