TIP: Line up and push
through all the bolts
on each side of the
table before you start
to tighten the nuts. If
you do not do this you
may find that you
cannot push through
the last bolts.
PAGE 11: This covers fitting the four
black curved legs to the body of the table
and the screwing of the yellow curved
end pieces to the wooden battens on the
inside of the red side pieces.
NOTE: The small screws on each of the
four curved legs are to help you line the
legs up in the correct positions. Do not
remove them. You must use the washers
on the nut side when fixing the legs. The
bolts used for this have a square section
at the flat end. As you tighten the nuts
this will be pulled into the wood. This is
correct but do not overtighten.
