Garland SCAR 112 E, Instruction Manual

Page: 29 / 112

English English
29/112
6.4. HOLDING THE CABLE EXTENSION
Only use cable extensions that are
certified for outdoor use. The cable
section must be at least 1.5mm, the
cable will have a maximum length of
25m and it must be fully unrolled before
starting to work.
Fix the cable extension to the fixing hook provided as
seen in the figure.
6.5. CONNECTING TO THE MAINS
It is mandatory that this machine is connected to
a switch protected by a differential whose current
is 30mA maximum. The tension must be 230V, the
frequency 50Hz and it must have a circuit breaker of
10A-16A.
Never use a damaged cable or a damaged electric
mains, or that does not comply with current normative
or those required for this machine. When using a
electric extension for the cable, make sure that it has
a minimum section of 1.5 mm2 and it should not be
longer than 25metres in length and homologated for
outdoor use. Both the plug and the base of the electric
extension must be waterproof and should never be
submerged in water. The use of an adequate electric
extension will reduce the risk of electric shock.
6.6. CHECKING POINTS PRIOR TO USING THE
MACHINE
Check all the machine and make sure that there are
no loose parts (screws, nuts, knobs etc) and any
damages to the machine.
Tighten, repair or replace all necessary equipment
prior to using the machine.
Check the state of the catcher and that it is properly
in place. Do not use the machine if it is damaged or
not properly regulated.
6.7. START UP AND STOPPAGE
Do not place hands or feet under the scarifier.
Maintain all body parts well clear from all cutting
elements when the machine is in use. Before starting
the scarifier, check that the cutting blades are not in
contact with any object.
Start up of the machine:
Press the security button (2) and without letting go of
it, pull upwards the bottom switch On/Off (1). UOnce it
has started, let go of the security butto.
Stopping the machine:
Let go of the bottom switch On/Off.
2
3
1
2
1